SUB-FRAME INSTALLATION Cont’d

Install Right and Left Rear Supports

Right Rear Support #1001380

Left Rear Support #100381

1.Install right rear support by inserting cap screw

(1) and flat washers (2) into position as shown in Figure 6.

NOTE: Install flat washers between rear support and pivot pin and on outside at head of cap screw as shown in Figure 5.

2.Install cap screw (3) and flat washer (2) in front hole(Figure 6). Only use one flat washer on outside at head of cap screw.

3.Install remaining two cap screws (1) and four flat washers (2) into position around pivot pin. Install flat washers both inside and outside of rear sup- port.

4.Install two cap screws (4) and flat washers (5) into bottom of tractor chassis as shown in Figure 7

5.Install left rear support, following steps 1-5.

Install Cross Member #1001387

6.Install cross member between right and left rear supports using four cap screws (3), flat washers (2) and hex nuts (6) as shown in Figure 7.

1.1001575 M14 x 2.0P x 55mm Cap screw

2.46070 9/16 Flat washer, hardened

3.33125 M14 X 2.0p X 50 mm Cap screw

4.30743 M16 x 2.0P x 45mm Cap screw

5.57817 5/8 Flat washer, hardened

6.307825 M14 x 2.0P Hex nut

2

1

Figure 5 Flat Washer Installation on Rear Support

Pivot Pin

1

23

2

Figure 6 Right Rear Support Installed

5 4

2 3 6

Figure 7 Rear Supports & Cross Member Installed

6 INSTALLATION

MAN0047 (9/15/00)

 

Page 8
Image 8
Woods Equipment BH9000 manual Install Cross Member #1001387