SETUP INSTRUCTIONS
WOODS
4.FINAL PREPARATIONS
-Check the engine and hydraulic oil levels. Top off with the correct oil if necessary. Use 10W30 motor oil for the engine. Use fresh, clean 20W50 motor oil for the hydraulic system.
-Insure Battery cables are connected properly.
Battery acid is caustic. Fumes are explosive and can cause serious injury or death.
Use insulated tools, wear protective glasses or goggles and protective clothing when working with batteries. Read and obey the battery manufacturer’s instructions.
Be certain the ignition switch is OFF and the key has been removed before servicing the battery.
a)Verify battery polarity before connecting or disconnecting the battery cables.
b)When installing the battery, always assemble the RED, positive ( + ) battery cable first and the ground, BLACK, negative ( - ) cable last.
c)Tighten cables securely to battery terminals and apply a light coat of silicone dielectric grease to terminals and cable ends to prevent corrosion. Keep terminal covers in place.
-Read Operation and Safety Manual before starting. Operator Manual is located under the seat. Tilt seat forward to access manual.
-If deck does not cut level, see deck leveling procedure in the Operator’s Manual
-Run engine at full RPM for 5 minutes before engaging blades to allow the engine to be fully lubricated before load is applied.
-Check the hydrostat neutral adjustment. Neutral is set at the factory but may require readjustment. See adjustments section in the operator’s manual.
-Do not use the machine without an approved grass collector, the grass discharge chute or mulching plates correctly fitted.
13
