WOODS

BELT REPLACEMENT

NOTE: Always use Woods replacement belts, not general purpose belts. Woods belts are specially designed for use on this mower and will normally last longer.

CUTTERDECK BELT

1.Remove floorplate.

2.Set the cutterdeck in a middle height-of-cut posi- tion.

3.Use a 3/8" ratchet and extension to back tensioning idler off to remove belt from idler. Remove belt from cutterdeck pulleys.

NOTE: Use the 3/8" ratchet in the square hole A on the idler.

4.Remove belt from clutch pulley.

5.Install the new belt by performing these steps in reverse order.

BELT TENSION

All belts are tensioned by spring loaded idlers and do not require any adjustment.

3 SPINDLE DECK

2 SPINDLE DECK

HYDRO TRANSAXLE DRIVE BELT

1.Remove cutterdeck belt (see cutterdeck belt replacement).

2.Disconnect wire I at clutch M. Remove bolts J and remove torque restraint.

3.Using a ratchet with a 9/16" socket, place over nut at location P. Use the ratchet to rotate it enough to remove the transaxle drive belt.

4.Install a new transaxle drive belt by performing these steps in reverse order.

5.Inspect the fans. Replace if worn or damaged. Torque transaxle pulley nut to 28.3-41.6 ft-lbs (38-56 Nm).

6.Reinstall cutterdeck belt (see cutterdeck belt replacement).

39

Page 39
Image 39
Woods Equipment CZR2242B, CZR2652B manual Cutterdeck Belt, Belt Tension, Spindle Deck Hydro Transaxle Drive Belt