ADJUSTMENTS
WOODS
HYDROSTATIC TRANSAXLE ADJUST-
MENTS
A turnbuckle style hydrostat neutral adjustment is provided.
Neutral:
1.Support the machine with the rear wheels off the ground. Use jackstands or equivalent sup- port. Do not rely only on mechanical or hydraulic jacks.
2.Move the traction levers out into the neutral lock position and raise the seat.
3.Disconnect the seat switch wire and temporarily connect the two terminals with jumper wire J as shown.
4.Start the engine and run at low speed.
5.Move parking brake to the OFF position.
6.Loosen jam nuts K at both ends of the control rod L.
7.Rotate the control rod until the corresponding wheel stops turning. Lock the control rod jam nuts. Run the engine up to high idle and stroke the traction levers forward and back to check the adjustment. Move traction levers back to neutral and readjust if necessary.
8.Repeat steps 6 and 7 for the opposite side.
9.Remove the jumper wire and reconnect the seat switch.
37
