1.Discharge chute

2.Side shield

3.Side skid

Figure 15. Side Skids, Side Shield &

Discharge Chute Installation

CROSSWISE SUPPORT INSTALLATION

Attach crosswise support to mower deck, welded lug forward. Insert spacer bushing into hole. Insert bolt through deck and slide support onto bolt and attach with nut.

1.Crosswise support

2.Spacer bushing

3.Keyhole brackets

4.Caplug

5.Lift chain

Figure 16. Crosswise Support Installation

CHANNEL ARM INSTALLATION

(Refer to parts drawing, page 32)

Attach push channels (12) to mower and secure with clevis pins (13) and safety pins (40). Pin crosswise rear support (15) between push channels and secure with clevis pins (13) and safety pins (40).

Secure center of crosswise rear support to mower with bolt (52), sleeve (16) and flange lock nut (55). After belt is installed, pin rear of channel arms to idler bracket with clevis pins (14) and safety pins (40).

LIFT CHAIN INSTALLATION (FIGURE 17)

Install chain idlers (3) to front lift bracket (2) with clevis pin (34) and cotter pin (21). Attach front lift bracket assembly to tractor clutch housing with metric bolts (31).

2.Front lift bracket

3.Chain idler

21. 3/16 x 1" Cotter pin

31.12 mm x 25 mm Metric bolt

34.1/2 x 2" Clevis pin

Figure 17. Lift Chain Installation

BELT INSTALLATION (FIGURE 18)

One of the major causes of belt failure is improper installation. Before a new belt is installed, check pulley shafts and bearings for wear. Check pulley grooves for cleanliness and be sure they turn freely and with only slight wobble. If grooves require cleaning, use a cloth moistened with a non-flammable, non-toxic degreasing agent or commercial detergent and water.

Avoid excessive force during installation. Do not use tools to pry belt into pulley groove. Do not roll belt over pulleys to install. This can cause hidden damage and premature belt failure. Always loosen idler pulleys prior to belt installation.

The belt may be completely installed with the mower mounted on tractor. However, it is easier to install belt on mower deck with mower detached. Remove belt shields.

Step 1. Insert belt in bottom right hand groove of center pulley and route around left pulley.

Step 2. Bring belt back to center pulley and insert in middle groove and thread around right pulley.

Step 3. Route belt to center pulley and insert in top groove and pull to rear.

Belt installation will be completed after mower is attached to tractor, as described on page 27.

24 Assembly

51642 (Rev. 11/9/2007)

 

Page 24
Image 24
Woods Equipment L59KR17-1 manual Crosswise Support Installation, Channel ARM Installation, Lift Chain Installation Figure