NOTICE
■Make sure front or rear tires do not rub on mower.
■Alignment must be rechecked if it is necessary to move idler pulleys or the mower deck to get proper belt tension.
■Tension on a new belt should be readjusted every half hour for the first two hours and then checked every eight hours of operation.
BELT SHIELD INSTALLATION (FIGURE 31)
Insert shield bolt through drawbar bracket and secure with lock washer (4) and hex nut (5). Attach top of shield (3) to tractor top link and secure with clevis pin
(1) and safety pin (2). | 1. Top link pin, tractor hardware | |
| 2. | Top link safety pin, tractor hardware |
| 3. | Belt shield |
| 4. | 3/8" Lock washer |
| 5. | 3/8 NC Hex lock nut |
|
| Figure 31. Belt Shield Installation |
DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
(Dealer’s Responsibility)
Inspect the mower thoroughly after assembly to be cer- tain it is set up properly before delivering it to the cus- tomer. The following check list is a reminder of points to inspect. Check off each item as it is found satisfactory or after proper adjustment is made.
___ Check that all safety decals are installed and in good condition.
___ Check that shields and guards are properly
| installed and in good condition. |
___ | Properly attach equipment to tractor and make all |
| necessary adjustments. |
___ | Check all bolts to be sure they are correctly |
| torqued. |
___ | Check that all cotter pins and safety pins are |
| properly installed. |
___ | Lubricate all grease fittings; check to make sure a |
| small amount of grease comes out of seal. |
___ | Check that blades have been properly installed. |
___ | Check mower attitude and belt alignment. |
DELIVERY CHECK LIST
(Dealer’s Responsibility)
___ Show customer how to make adjustments.
___ Explain importance of lubrication and show lubri- cation points to customer.
___ Point out all safety features of the equipment. Explain the importance and meaning of all safety decals and emphasize the potential hazards when not followed.
___ Present Operator's Manual and request that cus- tomer and all operators read it before operating equipment.
___ Show customer the safe, proper procedures to be used when mounting, dismounting, and storing equipment.
___ Explain to customer that when equipment is transported on a road or highway, a Slow Moving Vehicle (SMV) sign should be used to provide adequate warning to operators of other vehicles.
___ Make customer aware of optional equipment available so that customer can make proper choices as required.
51642 (Rev. 11/9/2007) | Assembly 29 |
| |
|
|
