Figure 19. Rear View of Tractor
5. V-Idler
8.Idler bracket
20.Belt guide
36.Carriage bolt
37.Hex lock nut
39.Washer
Figure 20. Idler Pulley Installation
IDLER BRACKET INSTALLATION
(See parts drawing on page 32)
Remove bolts holding muffler bracket to bottom of dif- ferential housing, just ahead of rear axle. Remove rear PTO tractor shield. Attach idler bracket (8) to tractor where shield was removed. Secure to tractor with hard- ware removed with shield.
Secure front four holes in idler bracket to tractor with metric cap screws (31). In the rear two holes, place muffler clamp against idler bracket and secure to trac- tor with metric cap screws. Tighten all hardware securely.
DRIVE PULLEY INSTALLATION (FIGURE 21)
Remove paint from center hole of drive pulley (4). Insert splined bushing (2) and key (3) into pulley. Insert bushing bolts (1) through unthreaded holes in bushing and start into threaded holes in pulley. Slide bushing and pulley onto tractor PTO shaft (5). Bushing will be flush with end of PTO shaft when properly aligned. Do not tighten bolts into pulley until belt is aligned (see Belt Alignment, page 27).
26 Assembly | 51642 (Rev. 11/9/2007) |
|
