Woods Equipment L59KR17-1 manual Tractor Preparation Figure, Idler Pulley Installation Figure

NOTICE

■A new belt will wear into pulley grooves and it may be necessary to move mower ahead or use other means of tightening after use.

„Make sure shields and guards are properly installed and in good condition. Replace if damaged.

TRACTOR PREPARATION (FIGURE 19)

It is necessary to remove some tractor components. Store them for later use.

Remove the sway chains, PTO shield, PTO protective cover and drawbar, if tractor is equipped with one.

IDLER PULLEY INSTALLATION (FIGURE 20)

Install carriage bolt (36) through left slide plate of idler bracket (8). Place three washers (39) and V-idler (5) over carriage bolt and secure with hex lock nut (37).

Install carriage bolt (36) through right slide plate of idler bracket (8). Place belt guide (20), two washers (39) and V-idler (5) over carriage bolt and secure with hex lock nut (37). Leave assembly loose until final belt adjustments are made.

Figure 18. Belt Installation

51642 (Rev. 11/9/2007) Assembly 25