Replacing Scarifier Tooth
1.Remove scarifier shank (1) from the scarifier bar.
2.Remove the worn tooth by driving a chisel between the shank (1) and tooth (2) .
3.Install replacement tooth and use a punch (3) to bend the locking tab (4) into the retaining hole on both sides of the shank (see Figure 7).
4.Reinstall the shank (1) in the scarifier bar.
1 |
4 |
2 |
3 |
Figure 7. Scarifier Point Replacement
CLEANING BOX SCRAPER & REAR BLADE
After Each Use
●Remove large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Inspect machine and replace worn or damaged parts.
●Replace any safety decals that are missing or not readable.
Periodically or Before Extended Storage
●Clean large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Remove the remainder using a
1.Be careful when spraying near scratched or torn safety decals or near edges of decals as water spray can peel decal off surface.
2.Be careful when spraying near chipped or scratched paint as water spray can lift paint.
3.If a pressure washer is used, follow the advice of the pressure washer manufacturer.
●Inspect machine and replace worn or damaged parts.
●Sand down scratches and the edges of areas miss- ing paint and coat with Woods spray paint of matching color (purchase from your Woods dealer).
●Replace any safety decals that are missing or not readable (supplied free by your Woods dealer). See Safety Decals section for location drawing.
MAN0561 (8/25/2006) | Maintenance 13 |
| |
|
|