OPERATION
The operator is responsible for the safe operation of this equipment. The operator must be properly trained. Operators should be familiar with the equipment, the tractor, and all safety practices before starting opera- tion. Read the safety rules and safety decals, page 5 through page 8.
The box scrapers and rear blades are designed for a wide range of applications: scarifying, scraping, level- ing, grading, and backfilling.
Power unit must be equipped with ROPS or ROPS cab and seat belt. Keep seat belt securely fastened. Falling off power unit can result in death from being run over or crushed. Keep foldable ROPS system in “locked up” position at all times.
Never allow children or untrained persons to operate equipment.
Keep bystanders away from equipment.
NEVER GO UNDERNEATH EQUIPMENT. Never place any part of the body underneath equipment or between moveable parts even when the engine has been turned off. Hydraulic system
•Service work does not require going under- neath.
•Read Operator's Manual for service instruc- tions or have service performed by a qualified dealer.
Keep hands, feet, hair, and clothing away from equipment while engine is running. Stay clear of all moving parts.
CAUTION
Stop power unit and equipment immediately upon striking an obstruction. Turn off engine, remove key, inspect, and repair any damage before resuming operation.
Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy,
CONNECTING ATTACHMENTS
This box scraper or rear blade should be mounted on tractors with a maximum engine rating of 35 hp and not to exceed 2000 lbs.
The box scraper and rear blade are compatible with Category 1,
Adjust or remove tractor drawbar to eliminate interfer- ence with box scraper or rear blade.
NOTICE
■The 3/4" bolt and sleeve in lower hole provide strength to the box scraper. Do not remove this bolt and sleeve when operating the box scraper. See Figure 1.
Figure 1. Attaching Box Scraper
Category 1
1.Place tractor
2.Secure with klik pin (not provided) as shown in Figure 2.
3.Attach the tractor's top link to the top of the attachment’s
4.Secure with the
Quick Hitch (Category 1)
(Refer to parts list drawings, page 18 & page 19.)
1.Use Bushing Kit #1022040 when using a quick coupler
2.Place lower sleeves (A) over lower hitch pins and secure with linch pins (B).
3.On the box scraper, replace the top spacer (9) with sleeve (D) by removing and replacing nut (6), washer (7), and bolt (8).
4.On the rear blade, install sleeve (C), bolt (E), washer (F), and nut (G) in the top link hole.
5.Align quick hitch with lower and upper sleeves and connect using the instructions with the quick hitch.
(Rev. 1/26/2007) MAN0561 (8/25/2006)