1.Place a 4" x 4" block under each end of snow- blower frame.
NOTE: Block only high enough for the skid shoes to clear ground.
2.Lower snowblower to sit securely on blocks.
3.Properly secure tractor and release all hydraulic pressure.
4.Loosen and remove skid shoe mounting bolts (3) and nuts (31).
5.Remove skid shoe and inspect (4).
6.Adjust skid shoe (4) to provide correct depth of cut.
7.Tighten mounting bolts (3) and nuts (31). Tighten to specifications given on torque chart.
3.1/2 NC x 1” Carriage Bolt
4.Skid Shoe
31.1/2 NC Lock Nut
Figure 13. Skid Shoe Adjustment
PTO Driveline Guard
The shield must turn freely on PTO shaft. Daily lubrica- tion of both shield bearings and periodic cleaning will ensure safe operation of the shield.
If shield is damaged or worn, replace components with genuine Woods service parts.
Walterscheid Driveline
1.Remove Phillips screw on driveline bell shield.
NOTE: In order to slide new bell over shaft guard, place bell in water at 180° F or in sun to expand bell temporarily.
2.Rotate bell shield until three reliefs align with white plastic collar.
3.Remove bell housing and shaft.
4.Replace components as needed. Follow steps 1 through 3 in reverse.
DP7
Figure 14. Walterscheid Driveline
Comer Driveline
1.Rotate three rectangular plastic pins with a screw driver 90°.
2.Lift pins out with screw driver.
3.Remove bell housing and shaft.
4.Replace components as needed. Follow steps 1 through 3 in reverse.
DP6
Figure 15. Comer Driveline
(Rev. 5/19/2011)
MAN0869 (04/13/2011)