4.Check oil level in the gearbox. Add as required.
5.Lubricate all grease points.
B.After operating for 5 to 10 hours:
1.Repeat items 1 through 4 of Section A.
2.Then go to normal Owner Service Section, page 16.
OPERATION
Each operator should review this section of the manual at the start of the season and as often as required to be familiar with the machine. When using, follow this pro- cedure:
1.Review and follow the
2.Review "Attaching Snowblower to Tractor" section, page 11.
3.Before going to the field, review "Transporting" section, page 14.
4.Position snowblower in a level area and lower into working position.
5.Starting Snowblower:
■Be sure area is clear of all bystanders.
■Run engine at low idle.
■Slowly engage PTO control to start machine.
■Slowly bring engine to rated PTO speed. Never exceed rated speed
6.Stopping Machine:
■Slowly decrease engine speed to low idle.
■Wait until PTO drive and snowblower have slowed to low engine idle speed before disengag- ing PTO drive.
Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the
Before performing any service or maintenance, disconnect driveline from tractor PTO.
7.Do not operate with bystanders in area. The machine can pick up stones, sticks, wire and other debris and throw it out with enough force to cause severe injury or death to bystanders. Shut down machine and wait for moving parts to stop before approaching machine.
8.Ground Speed: Travel speed can vary between 1.5 and 8 mph depending on material and terrain con- ditions. It is the responsibility of the operator to note the condition of the job being done and set the speed to obtain proper feeding rate and maintain safe control of machine.
9.The PTO driveline is equipped with a shear bolt, Figure 6, that protects drive system components from shock loads if machine strikes an obstruction. See parts section for bolt size and grade.
Figure 6. Shear Bolts
10.Operating Requirements:
Never direct discharge toward people, animals, or property.
■Know where you are operating. Remove all unwanted trash and debris before starting. It can wrap around auger or be thrown out of machine during operation.
■Keep auger and fan in good condition. Do not operate with a damaged fan or auger.
■Do not allow the auger to hit and scalp ground during operation. Hitting ground will pick up soil or rocks that can be thrown out of machine.
■To change direction of snow discharge, rotate the discharge chute. It will rotate 270°.
To move a discharge chute equipped with an optional hydraulic control, use tractor hydraulic control to direct discharge left or right within its 270° range. It will not rotate a full 360°.
NOTE: For hydraulic rotator option, if chute turns too quickly, adjust flow control on tractor hydrau- lics.
NOTE: Operating hydraulic deflector cylinder requires low tractor flow rates. When initially oper- ating cylinder reduce tractor hydraulic flow rate to
MAN0869 (04/13/2011) | Operation 13 |
|
|
