Woods Equipment T5040, T5070, T5060 Hydraulic Installation, Hose Kit, Connect and Route Hoses

58025 HOSE KIT

General Description

These set-up instructions are for operating the LUP126-2 or LUP132-2 loader using the tractor hydraulic rear remote control couplers. To use this hydraulic connection, the tractor must be equipped with two hydraulic levers and four tractor hydraulic couplers shown in Figure 11.

NOTE: Hydraulic couplers for connection to tractor are NOT INCLUDED with this hose kit but are avail- able as service parts.

Not all parts supplied in hose kit are used for this application.

Figure 11. Tractor Hydraulic Couplers

Connect and Route Hoses

1.Attach a 90-degree elbow (2) and male quick cou- pler (3) to each loader supply hose (1).

2.Connect loader supply hoses to loader feedlines as shown in Figure 12.

3.Route hydraulic hoses along loader mount, under the right side of operator's platform, and over the rear axle.

NOTE: Be sure to avoid contact with three-point linkage, brake pedals, and other moveable tractor components.

NOTE: Hoses must be routed so that they are not pinched, bent sharply, or chafed during operation. Hoses must not interfere with any tractor control operation or contact any moving parts.

Figure 12. Loader Feedline Identification

1.53670 Hose, 150" x 3/4 JICM x 3/4 JICM

2.313053 Elbow, 3/4 JICF x 1/2 NPTM 90°

3.66511 Quick coupler, male 1/2"

(not supplied in kit)

10 Hydraulic Installation MAN0788 (1/16/2008)