Woods Equipment T5070, T5060 Hydraulic Installation, Verification of Control Movements, Hose Kit

58025 Hose Kit

Verification of Control Movements
1. Mount loader to tractor: Remove mount pins	2
from loader uprights. Align tractor with loader and
	1
slowly drive tractor into loader. Shut off tractor.
2. Connect loader feedline hoses to tractor remote
hydraulic couplers. See Figure 12.
NOTE: At least 6" spacing should be maintained
between valve, bracket, or hoses and any tractor
control (brake pedals, accelerator, hand throttle,
or hydraulic levers).
3. Comply with all Safety Rules and start the tractor.
4. Mount loader to tractor by activating bucket cylin-
ders to raise or lower the loader uprights into the
loader mounts. Slowly advance tractor forward,
activating appropriate cylinders to engage loader
	● Control 1, Handle forward -
completely into mounts. Insert mounting pins to
secure loader.	Dump bucket or attachment
5. Check that all hydraulic control lever positions	● Control 1, Handle back -
	Rollback bucket or attachment
operate the loader movements correctly as
	● Control 2, Handle forward - Boom down
shown in Figure 15.
6. If loader movements do not respond correctly,	● Control 2, Handle back - Boom up
shut off tractor, relieve pressure, and reconnect	Figure 15. Tractor Control Operation (Typical)
properly. Loader control movements must be cor-
rect before proceeding.

7.Once all loader functions are correct, start the tractor and operate the loader to check for leaks. Purge any remaining air from the hydraulic sys- tem.

8.When hose routings and correct loader opera- tions are verified, identify each circuit by placing a matching colored band around the male and female quick-disconnect coupler set. The colored bands will make re-installation easier when the loader is removed from the tractor.

9.Be sure that adequate slack is left in the hoses so they can move as the loader moves through its full range of motion.

10.Attach plastic tie straps every 20" around the hoses to keep them tightly bound and away from contact with the ground or other moving parts on tractor.

11.Before operating the loader, make sure that the Pre-Delivery, Delivery, and Pre-Operation Check- lists in the Loader Operator’s Manual have been completed.

12 Hydraulic Installation MAN0788 (1/16/2008)