Woods Equipment T5070, T5060, T5040, T5050 Loader Mount Installation, Tractor Preparation

LOADER MOUNT INSTALLATION

■Only use this mounting kit for mounting Woods LUP126-2, LUP132-2 loaders on New Holland®

T5040, T5050, T5060, T5070 2WD & FWA tractors and Case IH® Farmall® 85U, 95U and 105U 2WD & FWA tractors. Any other use or modification of this mounting kit may result in serious injury or death.

„Safety instructions are important! Read all attachment and power unit manuals; follow all safety rules and safety decal information. (Replace- ment manuals and safety decals are available from your dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call 1-800-319-6637.) Failure to follow instructions or safety rules can result in serious injury or death.

CAUTION

„Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

NOTICE

■This equipment must be assembled and installed on the customer’s tractor by the Woods dealer. Dealer must thoroughly inspect equipment and complete each item on the PRE-DELIVERY CHECK LIST, DELIVERY CHECK LIST, and PROD- UCT REGISTRATION before equipment is released to the customer.

■Clean threaded holes in the tractor chassis thor- oughly using a tap of the proper size. Paint, rust, or debris in the threads may not permit cap screws to be installed and tightened correctly.

■The Dealer must ensure that front tractor tires do not contact the loader or loader mounting brackets during operation. Tires must be checked for possible contact at full turning radius and maxi- mum axle oscillation before operating the loader. See your tractor operator's manual for the proper adjustment procedure and adjust the front axle steering stops as required to obtain clearance.

Tractor Preparation	1.	Shut off engine and set parking brake during
For installing this mounting kit, references to right, left,		installation.
	2.	Remove the tractor front weights and front weight
forward, and rearward directions are determined from
the operator’s position in the tractor seat.		bracket if equipped.
NOTE: OEM loader ready brackets are required to	3.	Loose hardware securing OEM loader ready
		brackets to tractor. This will help align mounting
install this loader mount.
		holes with Woods loader mounts.
	4.	Follow tractor operator manual instructions and
		adjust tires to the widest recommended setting to
		increase the tractor stability.

As a valued customer, Woods appreciates your comments. Once loader mount and hydraulic hoses have been installed, please take a few minutes to complete the Loader Mount Evaluation sheet that was supplied with this mount. Your comments will help us continue to bring you quality products.

4 Mount Installation MAN0788 (1/16/2009)