Figure 46. Main power ON/OFF safety switch.
Figure 47. DO NOT stand in the path of where
the workpiece could be projected.
Figure 48. NEVER hold the workpiece where the conveyor and workpiece can pinch your fingers.
NOTICE
ALWAYS take a few moments to listen and observe for unusual noise and vibration after starting the Double Drum Sander.
To use the double drum sander, do these steps:
1.Twist and pull the emergency stop switch knob, and position your finger over the knob. Be ready to push the knob and shut the sander OFF if there is a problem. See Figure 46.
2.Push the sanding drum ON button and listen for any unusual noises. The sander must run smoothly with little or no vibration.
•If unusual noise or vibration exists, push the emergency stop switch immediately and unplug the sander.
•Troubleshoot the source of the noise or vibration, and correct the problem.
•ONLY adjust the sander when it is OFF and unplugged.
•ONLY restart the sander when you are sure the problem is corrected.
3.Start your dust collector.
DO NOT stand in the path where the workpiece could be projected. If you ignore this warning you could be severely injured or killed!
4.Place the workpiece on the conveyor table and turn the table height handwheel clockwise to raise the conveyor table until the stock barely touches the pressure roller. See Figure 48.
5.Push the feed motor ON button to start the feed conveyor.
6.See Figures 48 and 49 and feed the workpiece correctly where the conveyor cannot pinch your fingers.
OPERATIONS
