Woodstock W1715 manual Jklg

N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/

(.% Unthread the V-belt tension hex bolt, then pivot the motor up and slide the V-belt into the pulley grooves, as shown in =`^li\(-.

(/% Release the motor, letting its weight tension the V-belt, then thread the V-belt tension hex bolt against the side of the bandsaw.

(0% Install the work stop shaft into the side of the bandsaw then lock it in place by tightening the set screw, as shown in =`^li\(..

)'% Slide the work stop onto the end of the shaft and lock it into position with the locking lever, as shown in =`^li\(/.

V-belt Tension

Hex Bolt

=`^li\(-%Installing the V-belt.

J<KLG

=`^li\(.% Installing the work stop shaft.

Locking

Lever

=`^li\(/% Work stop locking lever

installed.

-16-