Woodstock W1715 manual Jklg

N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/

((% Place the pulley cover over the motor and gear shafts, and secure it with the pre-installed M6-1 x 12 Phillips head screws and 12mm flat washers, as shown in =`^li\(*.

()% Open the pulley cover, then insert the keys into the slots on the pulley shafts.

(*% Slide the large diameter motor pulley onto the motor shaft (see =`^li\(+).

(+% Install the worm gear pulley with the small diameter wheel on the shaft closest to the gear box.

(,% Use a straightedge to check the alignment of the	=`^li\(*% Installing the pulley cover.
pulley wheels, as shown in =`^li\(,, and adjust
them as needed.
(-%When the pulley wheels are aligned, tighten the set		Motor Pulley
		w/Key Slot
screws on both pulleys.

=`^li\(+% Motor pulley installed.

=`^li\(,% Checking the pulley alignment.

-15-

J<KLG