ASSEMBLY
To install the rip fence to the table saw, do these steps:
1.Thread the handle knob onto the fence locking handle.
2.Make sure the handle is in the unlocked “UP” position before placing the fence on the rails.
3.Check to see that the fence clears the table surface throughout its range of travel, and increase or decrease the height between the fence and table by adjusting the bolt shown in Figure 5.
4.Install the clear scale indicator to the right of the fence with the
W1720 Installation
The SHOP FOX® W1720
W1720 Hardware Bag Contents: | Qty | |
• | Flat Washer 1⁄4" | 8 |
• | 8 | |
• | Hex Nut | 8 |
• | Flat Washer 5⁄16" | 10 |
• | 10 | |
• | Hex Nut | 10 |
To install the W1720 fence rails to the table saw, do these steps:
1.Remove the fence, the standard rails, and the blade guard that came with the table saw, if they are installed.
2.In the front and back edge of the table, insert eight
Adjustment Bolt
Figure 5. Adjustment bolt.
Scale Indicator
Figure 6. Scale indicator.
Figure 7. Extension rail inventory.