3.Insert two 5⁄16"-18 x 3⁄4" T-bolts in the right table wing, and two into the edge of the left table wing, and install the flat washers and nuts on each bolt. See Figure 8.
4.Tighten all nuts until there is a gap of approxi- mately 3⁄16" to 1⁄4" between the T-bolt and the table and wing edges.
5.Slide the extension rail over the T-bolts as shown in Figure 1 until the rail is flush with the end edge of the left table wing.
6.Tighten all hex nuts.
7.On each leg flange fasten two 5⁄16"-18 x 3⁄4" T- bolts, flat washers, and the nuts; then slide the legs onto the rails as shown in Figure 9.
8.Tighten the hex nuts to secure the legs to the rails, and secure the rail end caps with the Phillips head screws.
9.Insert two 5⁄16"-18 x 3⁄4" T-bolts into the start switch mounting slot (see Figure 8), and posi- tion the start switch mounting bracket to the underside of the rail, and secure it with the washers and nuts.
10.Install fence, and adjust rails to fine-tune the mounting alignment of the rails and legs.
