ADJUSTMENTS
The SHOP FOX® W1716/W1720
Fence Parallelism
If your table saw has been properly adjusted, the saw blade should be parallel to the miter slot. Refer to your table saw manual for the proper procedure to check and adjust the saw blade to the miter slot correctly.
To adjust the SHOP FOX®
1.UNPLUG THE TABLE SAW!
2.Align the edge of the fence with the edge of the miter slot.
3.Lock the fence and check the alignment between the left edge and the miter slot.
4.Adjust the setscrews shown in Figure 13 to adjust the angle of the fence. Note— The left setscrew will move the fence left and the right setscrew will move the fence right.
5.Adjust the fence until the back end falls
1⁄64" away from the miter slot so the work- piece clears the opposite end of the saw blade without binding. This is called “lead”
(pronounced leed).
DISCONNECT power to the saw at this time! Otherwise, serious injury may occur.
Figure 13. Fence adjustment setscrews.
1 | ⁄64" |
|
Shown exaggerated for illustration purposes.
Figure 14. Lead adjustment.