Operation
When you have made all the required connections, switch on the mains supply. Flashing bars will be shown on the back panel display for approximately 30 seconds. During this time the speaker’s servo circuitry is stabilising and no audio will be issued. When the display changes to show the standby symbol (see table below), the speaker is ready to receive an audio signal.
Whenever the AKURATE 221 speaker is disconnected from the mains supply and then reconnected, wait until the standby symbol appears on the display before playing a disc.
Operating modes
Key to symbols
|
| SYMBOL | MODE | MEANING |
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Standby | The unit is waiting for an audio signal |
|
|
|
|
|
|
|
| In this mode the unit consumes minimal |
|
|
|
|
|
|
|
| power. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| On | The unit is fully |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
| The unit will enter this mode as soon as it |
|
|
|
|
|
|
|
| receives an audio signal. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Thermal Standby | The unit has overheated |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
| During very demanding, sustained use the |
|
|
|
|
|
|
|
| unit will go into Thermal Standby mode in |
|
|
|
|
|
|
|
| order to allow itself to cool down. When in |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
| this mode the unit will not produce any |
|
|
|
|
|
|
|
| sound. The unit will return to On mode |
|
|
|
|
|
|
|
| when its temperature has dropped to its |
|
|
|
|
|
|
|
| operating level. |
|
|
|
|
|
|
|
|
|
|
|
AKURATE 221 English 
Parameters
The AKURATE 221 speaker is equipped with seven adjustable parameters (see next page) that enable you to alter its performance to suit your taste.
Note:
The parameters can only be adjusted when the AKURATE 221 speaker is not in standby mode.
Adjusting the parameters
To select the parameter you wish to adjust:
●Hold FEATURE.
●Repeatedly press UP or DOWN until the letter for the desired parameter appears.
●Release FEATURE.
●Repeatedly press UP or DOWN to change the setting.
HP OUT
AL OUT
A IN
A few seconds after the last key press the display changes to -
To restore the default settings:
●Disconnect the AKURATE 221 speaker from the mains supply and wait for the display to go blank.
●While holding FEATURE reconnect the mains supply.
●Continue to hold FEATURE until the display shows H
A few seconds after releasing FEATURE the display changes to-
AKURATE Loudspeaker System
11 | Owner’s Manual |
|
