Woodstock W1717 instruction manual Stand Assembly, To assemble the work stand, do these steps

Stand Assembly

The Model W1717 Sander mounts onto a heavy duty metal work stand. This assembly will be fastened together using the supplied M8-1.25 x 12 carriage bolts, 8mm washers and 8mm hex nuts. Finger tighten the hardware at this time.

To assemble the work stand, do these steps:

1.Assemble two legs together with a lower short brace and an upper short brace as shown in Figure 3.

2.Install the long upper and lower braces to the assembled legs as shown in Figure 4.

3.Attach the remaining legs and short upper an lower braces as shown in Figure 5.

4.Slide the rubber feet onto the bottom of each leg to complete the stand assembly.

Figure 3. Assembled Legs.

Figure 4. Installed braces.

Figure 5. Remaining legs and

braces installed..

-11-