Management

Configuring the Spanning Tree Protocol

The IntraStack is shipped with Spanning Tree enabled on all ports.

You can disable or enable Spanning Tree on the IntraStack or on an indi- vidual port. You can also configure the Spanning Tree parameters on the IntraStack.

Important: Do not enable, disable, or configure the Spanning Tree Parameters unless you have knowledge and experience with the IEEE 802.1d specification.

Disabling or Enabling Spanning Tree

You can disable or enable Spanning Tree on the IntraStack or on an indi- vidual port.

To disable or enable Spanning Tree on the IntraStack:

1 Click swAgentSW.

The Switch Agent Software Group table appears.

2 Open the STP drop-down menu and select Disable (to disable Spanning Tree on the IntraStack) or Enable (to enable Spanning Tree on the IntraStack).

3 Click Apply.

Spanning Tree is disabled (or enabled) on the IntraStack.

To disable or enable Spanning Tree on a port:

1 Click PortCtrl.

The Port Control table appears, similar to Figure 4-16.

Page 4-26

Page 48
Image 48
Asante Technologies 6000 Series user manual Configuring the Spanning Tree Protocol, Disabling or Enabling Spanning Tree