Page 4-16
0.0.0.0.
Do NOT type an IP address of
▲ Important:
The Add Dialog box appears.
4 Open the Status drop-down menu and select valid.
5 Type the IP address of the management station that is to receive traps in the Trap Receiver Address field.
Click Add.
3
Click TrapRecv.
The Trap Receiver table appears, similar to Figure 4-12.
Figure 4-12 Trap Receiver table
Δ Note: For a description of each field, see “Trap Recv” on page 5-22.
If there are no entries, the table is blank.
2
allowed.
This section describes how to add and delete a trap receiver. To add a trap receiver entry:
1 Do not select any item on the Device Page’s front-panel image. (This selects the entire device.)
Management
Managing Trap Receivers
Trap receivers are the network management stations designated to receive traps from the IntraStack when they occur.
▲ Important: A maximum of four trap receivers is |
