-31-
W1737/W1738 Owner's Manual (Mfg. 10/09+)
MAINTENANCE
Feed Belt Tension and Tracking
Figure 46. One of four positioning wheels.
Positioning
wheel
The feed belt tension and tracking has been set at the
factory.However,adjustthefeedbelttension and
tracking if you notice that your feed belt is slipping or is
tracking off center and loading up against the positioning
wheels (Figure 46) under the conveyor table, you must .
To adjust the feed belt tension and tracking, do these
steps:
1. Turn the feed belt tension and tracking bolts equal
amountsfromside-to-sideandsetthebelttension
so it is snug and will not slip when sanding at a
maximum load.
2. Start the conveyor.
3. Turn the feed belt tension and tracking bolt to
position the feed belt roller evenly on each side.
See Figure 47.
—If the conveyor tracks to the right, turn the right-side
tension and tracking bolt clockwise approximately in
1⁄4 turn increments.
—Iftheconveyor tracksto theleft,turn theleft-side
tension and tracking bolt clockwise in approximately
1⁄4 turn increments.
4. Run the feed belt for at least three minutes to
determine if the tracking is correct and the tension
stays the same.
5. Repeat steps as required to achieve the correct
tension and tracking.
KEEP loose clothing and long hair
secured and away from moving parts.
Figure 47. Feed belt tension bolt.
Feed Belt
Tension and
Tracking Bolt