-29-
W1737/W1738 Owner's Manual (Mfg. 10/09+)
MAINTENANCE
Figure 41.SandingmotorV-belt
adjustment.
V-Belt TensionThe sanding motor (Figure 41) and table lift motor
(Figure 42)V-beltsmustbetensionedproperlyfor
bestperformance.Noadjustmentisnecessaryforthe
conveyor motor belt, as it uses a variable width pulley.
See Figure 43. Only replace the belt if it becomes
frayed,cracked,orglazed.Ifonebeltis bad,always
replace both belts as a matched set. Both table lift and
sandingmotorbeltsareadjustedthesameway.
To tension the V-belts, do these steps:
1. TURN OFF and LOCK the master power switch so
your sander cannot accidently start!
2. Remove the lower cover(s) on the sander (right
coverforsandingbeltmotor;leftcoverfor the
conveyor height motor).
3. Turnbothtensionadjustmentnutsclockwise
totightentheV-belts,orturnbothnuts
counterclockwisetoloosentheV-belts.
4. TheV-beltisproperlytightenedwhenitwillmove
no more than 3⁄4" in the center with moderate
pressure from your thumb.
Tension
Adjustment
Nut
Figure 42.TableliftmotorV-belt
adjustment.
Tension
Adjustment
Nut
Figure 43.Non-adjustableconveyormotor
belt.
Variable
WidthPulley
KEEP the sanding drum drive belts correctly adjusted.
If the belts are loose, and the emergency stop is
engaged, the sanding drum pulley will slip and not
immediately stop in the event of an emergency!