-23-
W1808/W1809/W1810 Cyclone Dust Collectors
SET UP
17. Model W1810: Mount the two filters to the cross
braces with brace gaskets between them, as shown
in Figure 26, using (8) 5/16"-18 x 3/4" hex bolts and
(8) 5/16" fender washers.
Model W1808-9: Mount the filter to the L-braces with
brace gaskets between them using (4) 5/16"-18 x 3/4"
hex bolts and (4) 5/16" fender washers.
18. Model W1810: Connect (2) 8" x 23" flexible hoses, (2)
8" noise reducers, and (2) 8" x 4" flexible hoses to
the outlet ports and filters using (8) 8" hose clamps
as shown in Figure 27. Extend the ribbed part of the
hoses at least 1/2" past the outlet and filter ridges
(Figure 26) and secure with the clamps.
Model W1808: Connect a 7" x 18" flexible hose, 7"
noise reducer, and a 7" x 4" flexible hose to the out-
let ports and filters using (4) 7" hose clamps.
Model W1809: Connect an 8" x 19" flexible hose, 8"
noise reducer, and an 8" x 4" flexible hose to the
outlet ports and filters using (4) 8" hose clamps.
Note: Try tapping gently on the ribbed part of the
hose coils with a rubber hammer and a soft wood
block to fit them onto the noise reducers.
19. Model W1810 Only: Attach the lower stand legs to
the upper stand legs, as shown in Figure 28, using
(24) 3/8"-16 x 3/4" hex bolts, (48) 3/8" flat washers,
and (24) 3/8"-16 lock nuts.
Figure 26. Filters mounted to cross
braces.