Woodstock W1813 manual gcXZ`efem\pfi9\ck, Kfi\gcXZ\k\Zfem\pfiY\ck#fk\j\jk\gj1

N(/(*(/Fg\e<e[N`[\9\ckJXe[\i

I\gcXZ`e^:fem\pfi9\ck

If the conveyor belt becomes damaged or too worn to prop- erly adjust the tension, you must replace it.

KffcjE\\[\[	Hkp
Hex Wrench 4mm	1
Hex Wrench 5mm	1
Wrench 10mm	1
Wrench 12mm	1
Kfi\gcXZ\k_\Zfem\pfiY\ck#[fk_\j\jk\gj1
(% DISCONNECT THE SANDER FROM POWER!

)% Remove the cap screws and flat washers securing the front and rear conveyor roller guards (see =`^li\ *-), then remove the guards.

*% Loosen the conveyor tension jam nuts on either side of the conveyor (see =`^li\*.), then release the tension on the conveyor belt by loosening the ten- sion adjustment bolts.

+% Remove the three cap screws securing the c\]k front roller bracket shown in =`^li\*., then, while sup- porting the front conveyor roller assembly with one hand, remove the bracket.

,% Carefully pull the front conveyor roller assembly from the conveyor belt.

Note: 8kk_`jgf`ek#k_\]ifekifcc\iYiXZb\k`jjk`cc XkkXZ_\[kfk_\Zfem\pfifek_\i`^_kj`[\Xe[n`cc jkXp`egcXZ\%

Sander Assembly

Mounting Brackets

Roller Guards

=`^li\*-%Sander assembly mounting brackets and conveyor roller guards.

Cap Screws	Roller Bracket
	Tension Adjustment
	Bolt & Jam Nut

=`^li\*.% Roller bracket mounting cap screws and conveyor tension adjustment bolt.

NOTICE

Take care not to scratch or dent the surface of the front conveyor roller as you remove it from the sander. Damage to the conveyor roller could result in premature wear of the conveyor belt.

Continued on next page

-37-

J<IM@:<