Woodstock W1813 jkIle, Kfk\jkilek\dXZ`e\#fccfnk\j\jk\gj1, gcXZ\d\ek on GX\ for detailed

N(/(*(/Fg\e<e[N`[\9\ckJXe[\i

J<KLG

K\jkIle

Once the assembly is complete, test run your machine to make sure it runs properly and is ready for regular opera- tion.

The test run consists of verifying the following: 1) The motors power up and run correctly, 2) the emergency stop button safety feature works correctly, 3) the conveyor ON/ OFF switch disabling key works correctly, and 4) the air pressure safety switch operates properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review KiflYc\j_ffk`e^ on GX^\+,.

If you still cannot remedy a problem, contact our Tech Support at (360) 734-3482 for assistance.

Kfk\jkilek_\dXZ_`e\#]fccfnk_\j\jk\gj1	.%
(% Make sure you understand the safety
instructions at the beginning of the manual,
and verify that the machine is set up prop-
erly.
)% Ensure all tools and objects used during
setup are cleared away from the machine.
*% Connect the compressed air source to the
machine (refer to :fdgi\jj\[8`ion GX^\
(, for detailed instructions).
+% Confirm the sanding belt is installed,	/%
properly tensioned (refer to JXe[`e^9\ck
I\gcXZ\d\ek on GX^\)' for detailed	0%
instructions), and the sanding belt door is
closed and secured.
,% Connect the machine to the power source—
the power light on the control panel should
light.
-%Push the emergency stop button in, then
twist it clockwise so it pops out. When
the emergency stop button pops out, the
switch is reset and ready for operation (see
=`^li\(+).
Efk\1;li`e^k_\e\okjk\g#pfln`cc_\Xi
Xd\kXcc`Zk_ldgn_\ek_\jXe[`e^Y\ck
Z_Xe^\jfjZ`ccXk`fe[`i\Zk`feÇk_`jef`j\`j
efidXc%
	-16-

	N
K	@J	K
		

KfI\j\kJn`kZ_%%%

Kn`jk9lkkfe:cfZbn`j\

=`^li\(+% Resetting the switch.

Push the sanding motor ON button to verify the machine starts and operates correctly.

—When operating correctly, the machine runs smoothly with little or no vibration or rubbing noises.

—Investigate and correct strange or unusu- al noises or vibrations before operating the machine further. Always stop the machine and disconnect it from power before investigating or correcting poten- tial problems.

Press the emergency stop button to turn the machine F==.

WITHOUT resetting the switch, press the sanding motor ON button. The machine should not start.

—If the machine does not start, the emer- gency stop button safety feature is work- ing correctly.

—If the machine does start (with the emer- gency stop button pushed in), immedi- ately disconnect power to the machine. The emergency stop button safety fea- ture is not working correctly. This safety feature must work properly before pro- ceeding with regular operations. Call Tech Support for help.