@EKIF;L:K@FE
N(/(*(/Fg\e<e[N`[\9\ckJXe[\i
@EKIF;L:K@FE
Nff[jkfZbK\Z_e`ZXcJlggfik
This machine has been specially designed to provide many years of
Woodstock International, Inc. is committed to customer satisfaction. Our intent with this manual is to include the basic information for safety, setup, operation, maintenance, and service of this product.
We stand behind our machines! In the event that questions arise about your machine, please contact Woodstock International Technical Support at (360)
DXZ_`e\Fm\im`\n
An open end wide belt sander is designed to surface sand a workpiece that is twice the width of the sander's capacity by rotating the workpiece 180° for the second and subsequent sanding passes.
The operator uses the elevation handwheel and scale to set the depth of cut, turns the sanding and con- veyor motors FE, sets the feed rate or speed of the conveyor belt, then feeds the workpiece into the sander at the same rate as the conveyor. Pressure rollers keep the workpiece held to the conveyor belt to move it under the sanding drum. After each pass, the operator lowers the sanding belt the recom- mended amount and feeds the workpiece through the sander again.
The oscillation system shifts the sanding belt from
The depth of cut safety bar prevents a workpiece that is too high from being "jammed" into the sanding belt, which could produce an unsafe hazard of kickback. As well, the air pressure safety switch will not allow the machine to operate if the source of compressed air is below the operating minimum.
If you need the latest edition of this manual, you can download it from _kkg1&&nnn%j_fg]fo%Y`q. If you have comments about this manual, please contact us at:
Nff[jkfZb@ek\ieXk`feXc#@eZ%
8kke1K\Z_e`ZXc;fZld\ekXk`feDXeX^\i
G%F%9fo)*'0
9\cc`e^_Xd#N80/)).
<dX`c1dXelXcj7nff[jkfZb`ek%Zfd