INSTRUCTIONS (continued)
FLIPPING THE HARROW FROM
HARROWING TO TRANSPORT
POSITION AND VISE VERSA
Pull the harrow to a level location. Unhook the harrow from the tractor or ATV drawbar and move the tractor/ATV out of the way. (FIG. E)
Install the two 1/2” x 31/2” shift pins to lock the tongue assembly in the ridged position (pins go from outside toward the center). (Top part of FIG. A)
With the handle on the harrow, adjust the harrow teeth to an almost flat position (handle forward). (FIG. B)
Lift the harrow tongue and raise the harrow to a verti- cal position. The harrow should be able to stand alone in a vertical position while you walk around to the other side of the harrow. (FIG. C)
Reach up and grab the harrow tongue and gently pull the tongue toward you. Remember as the tongue comes toward you, on the “wheel side” of the harrow, it may require placing one foot on the rear crosstube as you pull the tongue downward. You will be taking more of the weight of the harrow as the harrow lowers. (FIG. D)
Once the harrow is flipped over and horizontal on the ground, back your tractor or ATV up to the tongue and reconnect to the unit.
CAUTION!
Do not leave the harrow in a vertical position. The harrow could fall over and hurt someone. If you are placing the harrow in a vertical position for storage, secure the harrow so it cannot fall over.
10
