Xantech MX88 installation instructions Composite Video

Model MX88 Page: 23

1.If the "+" (positive) and "–" (negative) terminals on your speakers are correctly marked, and visible, and you have wired the system with the positive speaker connector on the rear of the MX88 Controller/Amplifier connected to the positive connector on the speaker and the negative speaker connector on the rear of the MX88 Controller/Amplifier connected to the negative connector on the speaker, then the system will be "in phase". No further action is required. Most manufacturers identify the positive terminal with a red binding post, a "+" sign, or a red dot.

2.If you are unsure of the markings, you can verify that the two speakers are connected in phase. Using a mono sound source, such as AM radio, alternately reverse the leads to one of the speakers. Pick the connection that delivers a solid center image between the speakers as well as best bass response. CAUTION: After lead ends are inserted and the screws tightened down, be sure there are no free strands that could cause a short!

VIDEO CONNECTIONS – MX88VI ONLY

Composite Video

The buffered, composite video output from the MX88vi Controller/Amplifier will drive a VIDEO INPUT on a TV or monitor directly. Use RG6 coaxial or RG59 quad-shield cable with RCA-type phono plugs on each end. This connection can be run for 100 feet.

© 2010 Xantech LLC