Xantrex Technology 1500 manual to be approximately ¾ full

	Figure 2-2Battery level Indicator
	When the battery pack is fully charged, all four lights will illuminate.
	When discharged (empty), only the red light will illuminate and the
	battery pack must be recharged promptly. Figure 4 shows the battery pack
	to be approximately ¾ full.
	Battery charge level is indicated most accurately when the battery pack
	has been unused for 15 minutes. Pressing the Battery Status Switch while
	supplying power to an AC product may result in a false battery charge
	level reading.
AC Outlets	Turning this switch ON supplies power to both AC Outlets. An audio tone
Switch /	sounds briefly when the AC Outlets are turned on. The POWER light
POWER Light /	illuminates to confirm the AC Outlets are on. Turning this switch OFF
AC Outlets	cuts power to the AC Outlets. When the POWER Light is off, the AC
	Outlets are off.
	Important: The vents around the AC Outlets should never be covered or
	blocked when XPower 1500 is used. These vents are essential for maintaining
	optimal performance.
Fault Light	The FAULT Light illuminates when automatic shutdown occurs as a
	result of low battery voltage, overload, or over temperature conditions.
	See “Automatic Protection: Overload, Overheating, and Low Battery” on
	page 2–10for details.
DC Power	As shown in Figure 5 below, the DC Power Panel contains the DC Power
Panel	Socket, which provides 12 volts for operating automotive and marine type
	products. The DC Power Socket also serves as the input for recharging
	with either the AC Charger or DC Charging Cable. See “Recharging
	XPower 1500” on page 2–16for details.

2–6 445-0127-01-01