14
975-0123-01-01 Rev A
Mounting the Remote (Step 3)The remote can be permanently installed in a wall or cabinet.
The unit can also be flush-mounted into a rectangular opening in a wall
or surface-mounted using a double-gang, non-metallic outlet box.
To flush mount the remote, an opening must be cut in the backing
material to allow room for the circuit board, wires, and connectors.
Allow at least 1 ½ inch minimum clearance behind the circuit board for
the connectors and wires.
Important:
Use great care when cutting out the area for the circuit board
from the backing material (i.e., wallboard). Ensure there is enough area left to
securely hold the screws.
Figure 8
Minimum Clearance for the Remote
Faceplate
Circuit Board
Ports 1.5" (38 mm)
Minimum Clearance