Xantrex Technology Powerpack 300 manual Jump-Starting a Vehicle’s Engine

Jump-Starting a Vehicle’s Engine

If no alarm sounds, and the Green Jumpstart Connection LED is illuminated, then proceed to the next step.

7.Switch ON the jump-starting power switch. Before starting the engine, make sure the XPower Powerpack and the cables are clear of belts and fans.

8.Crank the engine for 4 seconds or until it starts, whichever is first.

WARNING: Fire hazard

Do not crank the engine for more than 4 seconds. The jump-start feature is designed for short term operation only. Operating the jump-start feature for more than 4 seconds may cause damage to the unit. Allow the XPower Powerpack to cool down for at least 3 minutes after each jump-start.

9.Switch OFF the jump-starting power switch.

10.Remove the red positive (+) clamp and then the black negative (–) clamp from the vehicle.

11.Store the jump-start clamps in the appropriate holder on each side of the XPower Powerpack.

Important: Recharge the XPower Powerpack as soon as possible after each use. See “Recharging the XPower Powerpack Battery” on page 28.

20