Troubleshooting Reference

 

 

 

 

Table 5-1Troubleshooting reference

 

 

Problem

 

Possible Cause

 

Solution

 

 

 

 

 

 

 

The engine

 

XPower Powerpack

 

Recharge the XPower

being jump-

 

battery is not fully

 

Powerpack battery.

started will not

 

charged.

 

 

start.

 

The engine condition is

 

Have the engine serviced.

 

 

 

 

 

poor.

 

 

 

 

The engine start capacity

 

Use a higher power XPower

 

 

exceeds the XPower

 

Powerpack.

 

 

Powerpack jump-start

 

 

 

 

capability.

 

 

 

 

 

 

 

The jump-start

 

Jump-start power switch is

 

Turn the jump-start power

clamps

 

OFF.

 

switch ON.

measure zero

 

 

 

 

volts.

 

XPower Powerpack

 

 

 

 

battery needs to be

 

 

 

 

recharged.

 

 

 

 

 

 

 

The

 

The valve connector may

 

Make sure the valve connector is

compressor

 

not be securely placed on

 

securely placed on the valve

runs, but won’t

 

the valve stem.

 

stem before closing the thumb

inflate.

 

 

 

latch.

 

 

The item being inflated

 

Make sure the item being

 

 

may have a leak.

 

inflated doesn’t have a leak.

 

 

 

 

Check the compressor hose for

 

 

 

 

any breaks or leaks.

 

 

 

 

 

The

 

The compressor may have

 

Turn off the compressor and let it

compressor

 

overheated from excessive

 

cool down.

runs slowly.

 

use.

 

 

 

 

Battery voltage is too low.

 

Check the condition of the

 

 

 

 

internal battery. The battery may

 

 

 

 

need to be recharged or replaced.

 

 

 

 

 

39

Page 52
Image 52
Xantrex Technology Powerpack 300 manual Switch on