Xantrex Technology XPF 35-10 manual Output Specifications

Specification

OUTPUT SPECIFICATIONS

Voltage Range:	0V to 35V
Current Range:	0A to 10A
Power Range:	Up to 175W
Output Voltage Setting:	By coarse and fine controls.
Output Current Setting:	By single logarithmic control.
Operating Mode:	Constant voltage or constant current with automatic cross-over
	provided that the power demanded stays within the power
	envelope, see graph. Outside of this envelope the output becomes
	unregulated.

Output Switch:	Electronic. Preset voltage and current displayed when off.
Output Terminals:	4mm terminals on 19mm (0·75”) pitch. 15A max.
Sensing:	Switchable between local and remote. Spring-loaded push
	terminals for remote connection.
Output Impedance:	Typically <5mΩ in constant voltage mode.
	Typically >5kΩ in constant current mode (voltage limit at max).
Output Protection:	Forward protection by Over-Voltage Protection (OVP) trip;
	maximum voltage that should be applied to the terminals is 50V.
	Reverse protection by diode clamp for reverse currents up to 3A.
OVP Range:	10% to 110% of maximum output voltage set by front panel
	screwdriver adjustment.
Line & Load Regulation:	<0.01% of maximum output for a 10% line change; <0.05% of
	maximum output for a 90% load change.
Ripple & Noise	5mVrms max; typically <2mVrms, <20mV pk-pk, both outputs fully
(20MHz bandwidth):	loaded (7A @ 25V), CV mode.
Transient Load Response:	<2ms to within 100mV of set level for 90% load change.
Temperature Coefficient:	Typically <100ppm/°C
Status Indication:	Output on lamp.
	Constant voltage mode lamp.
	Constant current mode lamp.
	Unregulated (power limit) lamp
	Trip message on display.
	3