Yamaha 01V96 Stero Input Channel

Stero Input Channel 11

Studio Manager for 01V96—Owner’s Manual

Stero Input Channel

A SOURCE parameter

This parameter is used to select an Input source. To select an Input

source, click the parameter and choose from the list that appears.

B Routing buttons

These buttons are used to route the Input Channel to the Bus

Outs.

C STEREO button

This button is used to route the Input Channel’s signal to the

Stereo Out.

D PHASE button

This button is used to reverse the signal phase of the channel.

E EQ button

This button is used to turn on and off the Input Channel’s EQ.

F EQ curve

This display shows the Equalizer’s curve, which can be

set by dragging.

G Channel number

This is the channel number.

H AUX section

These controls are used to set the levels of the Aux Sends. To set

an Aux Send level, drag its bar or click a point along the length

of the bar. To turn an Aux Send on or off, click its number.

I Pan/Aux Send display

This display shows the stereo or surround pan position or, while

setting an Aux Send, the Aux Send level in dB.

J PAN control

This control is used to set the Input Channel’s stereo or sur-

round pan position. When the PAN CONTROL in the Master

Section is set to “STEREO,” the Pan control appears as a rotary

control, and when set to “SURR,” the control appears as dot on

a pan graph. The surround pan position can be set by dragging

the dot. If you click on the pan graph while holding down the

Shift key, the pan immediately jumps to the new position.

K LFE control

When 5.1 or 6.1 Surround mode is selected, this con-

trol is used to set the surround LFE Channel level. It

appears when the PAN CONTROL in the Master Sec-

tion is set to “SURR.” To set the LFE level, drag the end of its bar

or click a point along the length of the bar.

L SELECT button

This button is used to select either channel R or L to operate by

the PAN control (J).

M SOLO button

This button solos the Input Channel. It appears orange while the

channel is soloed.

N ON button

This button turns the Input Channel on and off. It appears orange

while the channel is on.