Yamaha 01X Internal effects 1/2

01X Owner’s Manual
Overview of the 01X
31
Before UsingBasics SectionAppendix Getting StartedReference
Monitor output/headphone output
For monitoring purposes, the 01X provides MONITOR
OUT jacks and a PHONES jack. The MONITOR OUT
jacks and PHONES jack always output the same signal,
and is linked to the level adjustment. You can monitor the
output directly (monitor cascade) through the connected
speaker system/headphones (according to the [MONITOR
A/B] setting), if the stereo master output of the DAW is set
to the last two available channels (the last two numbered
channels specified with mLAN Auto Connector; refer to
the separate Installation Guide). (Refer to “Monitor” on
page 96.)
Internal effects 1/2
The two built-in effect units deliver a wide variety of
effects including spatial-type effects such as reverb and
delay, modulation type effects such as chorus and flanger,
and guitar-type effects such as distortion and amp simula-
tion. These effects can be used via Aux send (the level cor-
responds to the master level of the stereo input channels),
or inserted into a desired channel.
• If 88.2kHz/96kHz operation is enabled, only one internal effect block
is available (Effect 1/Aux 3).
•For details about each Effect Type, refer to page 125; for details
about each Effect Parameter, refer to page 126.
•For an application example showing how to use the effects, see page
57.
(MONITOR CASCADE)
STEREO R
STEREO L
(MONITOR IN)
mLAN STEREO IN L
(MONITOR IN)
mLAN STEREO IN R
PHONES
-10dBV
L
R
MONITOR OUT
DA
DA
Min Max
BAL
MONITOR
A/B
(Mix Balance)
MONITOR/
PHONES Knob
EFFECT 1
AUX3
INSERT SEND 24
*1
SELECT
EFFECT
EFFECT 2
AUX4
INSERT SEND 24
*1
SELECT
EFFECT
INPUT SELECT (INPUT PATCH)
2 2
22
EFFECT2 is available in
48kHz/44.1kHz mode only.
*1 Wordclock 96kHz/88.2kHz : 16
*3 Studio Manager only
FX1
FX2
METER
*3
(FX)
METER
*3
(FX)