Operation by the TV remote control is difficult (with unit beneath/under TV)

TV remote control operation may be difficult if the unit hides the sensor of your TV when beneath or under the TV. Try the two solutions below and see whether this solves the problem.

1Move the unit in all directions.2Remove the stands to lower the height of the unit.Use a + driver to remove the screws. The unit will be19 mm lower without the stands.

Note

Keep the stands and screws in a safe place for future use.

Additional Information

2 Press both the VOLUME + button and button of the main unit, release the button first, then release the VOLUME + button.

The unit is turned on when switching the TV remote control relay function on/off.

The CLEAR VOICE indicator lights up as the following illustration. Check if the setting is correct. (☞ P. 11)

 

On

Off

The CLEAR

 

 

 

 

 

 

VOICE indicator

 

 

 

 

 

 

 

 

 

 

 

 

(for 2 seconds

 

 

 

 

 

 

 

 

 

 

 

 

after the unit is

 

 

 

 

 

 

turned on)

No light

Green

 

 

 

 

 

 

 

•The default setting is off.

•You can verify the current setting by turning the unit on again from standby mode.

Notes

•Move the unit in all directions again if TV remote control remains difficult.

•The TV remote control relay function is enabled even if the unit is in standby mode.

English

 

 

 

Operate the unit by TV remote control

 

Using TV remote control relay

 

 

 

(TV remote control learning function)

 

function

 

 

 

 

 

If you cannot solve the problem by the suggestions above, follow the procedure below and use the TV remote control relay function, which relays the TV remote control signal received at the front of the unit to the remote control sensor of your TV through the TV remote control signal transmitter at the rear of the unit.

The remote control sensor of your TVTV remote control signal transmitter

1 Set the unit to standby mode.

You can use the TV remote control solely to operate by having the unit learn the TV remote control operations. You can operate the following functions by TV remote control.

•Volume down•Volume up•Power on/standby mode

y

Some TV remote controls may not control these functions. Use the remote control supplied with the unit in this case.

1 Set the unit and TV to standby mode.

2 Press both the INPUT button and button of the main unit, release the button first, then release the INPUT button.

The unit enters the remote control learning mode.Flashes inredContinued to the next page. \9 En