Additional Information
3 Press the button below of the main unit to select the operation you want the unit to learn.
Operation you | The button | The Indicator | |
want the unit to | |||
of the unit | flashes in green | ||
learn | |||
|
| ||
Volume down | VOLUME – |
| |
|
|
| |
Volume up | VOLUME + |
| |
|
|
| |
Power on/standby |
|
| |
mode |
|
| |
|
|
|
4 Point your TV remote control at the remote control sensor and press the respective button twice or three times until the indicator changes from flashing green to lit green.
Notes
•The unit will automatically set to standby mode if the unit in the remote control learning mode is left turned on for 5 minutes without any operation being performed.
•If learning fails, try again with your TV turned off. Note that screen glare may disturb TV remote control learning.
Removing all learned TV remote control operations
1 | Set the unit to standby mode. | |||
2 | Press both the INPUT | |||
| button and | button of the | ||
| main unit, release the |
|
| |
|
| |||
| button first, then release the |
|
| |
|
| |||
| INPUT button. | Flashes in | ||
|
| red | ||
Approx.
30 cm
(1 ft)
Indicator
e.g. Volume up
Release the 
button of the main unit when all the indicators light up in green. The unit enters standby mode.
3 Press the INPUT button of the main unit again for more than 3 seconds.
4 Release the INPUT button of the main unit when qD DTS indicator flashes.
Press the 
button of the main unit for more than 3 seconds to finish the remote control learning mode, or to have the unit learn operations of another TV remote control.
Resetting the unit
Should the unit freeze for any reason, this may be remedied by initiating the factory settings.
1 Set the unit to standby mode.
button of the main unit for more than 3 seconds.
button of the main unit.