mConnecting speakers

Connect the SPEAKERS terminals to your speakers with the wire with the proper gauge (keep it as short as possible). If the connections are faulty, no sound will be heard from the speakers. Make sure that the + and – polarity markings of the speaker wires are observed and set correctly. If these wires are reversed, the sound will be unnatural and lack bass.

cOne or two speaker systems can be connected to this unit. If you use only one speaker system, connect it to either the SPEAKERS A or B terminals.

cUse speakers with the specified impedance shown on the rear of this unit.

Caution

Do not let the bare speaker wires touch each other or any metal part of this unit. This could damage this unit or the speakers, or both.

How to Connect:
SPEAKERS A terminals
SPEAKERS B terminals

Red: positive (+)

Black: negative (–)

1

2

Red: positive (+)

Black: negative (–)

 

 

1 Loosen the knob.

 

2

2 Insert the bare wire.

 

[Remove approx.

1

 

 

10 mm (3/8”)

 

insulation from the

3

speaker wires.]

3 Tighten the knob

 

 

and secure the wire.

3

1Loosen the knob.

2Insert the bare wire. [Remove approx.

10 mm (3/8”) insulation from the speaker wires.]

3Tighten the knob and secure the wire.

<U.S.A., Canada, Australia, China and General models only>

Banana Plug connections are also possible.

1

2

1Tighten the terminal knob.

2Simply insert the Banana Plug connector into the terminal.

E-8