Random Tape Programming
The unit will automatically program tracks on a disc in random sequential order for recording to tape.
TRACK PROGRAMMING FOR RECORDING
Notes
• | Because the programmed data changes every time the |
| RANDOM button is pressed, the amount of time remaining |
| at the end of the tape also changes accordingly. |
• | It is recommended that you use a tape that is slightly longer |
DISC SCAN |
| DISC SKIP | |
|
|
|
|
REPEATRANDOM
CDC8 WH26170
2
3
in length than the CD you are recording, because the |
programmed tracks on a CD may not fit properly into the |
time allowed on each half of the tape. |
• CD synchronized recording function can be used if your tape |
deck is compatible with it. |
In this case, in steps 3 and 4, press the SYNCHRO button |
and then press the w button. Recording automatically starts. |
(For details, refer to page 17.) |
Display information during programming
3
|
|
|
|
|
1 2 3 4 5 | PROG |
|
|
|
1 3 5 |
| |||
|
| 7 |
|
|
4 13:00
1Follow steps 1 to 3 on page 18.
2Press the RANDOM button.
RANDOM
The unit will automatically program tracks for side A and side B separately considering the total time of the tape.
*The programmed track numbers and the total number of tracks for side A and B are displayed for a short time.
3Start recording on the tape deck and press the w button at the same time.
4The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and, at the same time, press the w or d button.
12
1 Shows the number of programmed tracks for each side in turn just after the automatic programming is finished, and then it is replaced by the number of the first programmed track for side A.
2Shows the total time of programmed tracks for each side.
3 Shows the programmed track numbers for each side.
RECORDINGFUNCTIONS FOR
English
21En
