VARIOUS FUNCTIONS
■Display information during programming
1 2 3 4 5 SEARCHPROG
-- STEP 1
1
|
| 2 |
|
|
| 4 | |
1 | 2 | 3 | 4 | 5 | SEARCH | PROG | |
6 | |||||||
|
|
|
|
|
| ||
| 6 |
|
|
| 3:25 | ||
|
|
|
|
|
| 3 |
1Shows the program number for the track to be programmed next.
2 Shows the selected disc and track number.
3 Shows the total time of the tracks currently programmed.
4 Shows only the numbers of programmed tracks on the selected disc.
*If “STEP 1” does not appear on the display after the PROG button is pressed, press the TEXT/TIME display
*If the total time exceeds 99 minutes and 59 seconds, the time will not be displayed.
Notes
• You can program as many as 40 tracks at one time.
• You can program a whole disc by pressing “0”, instead of one track. At that time, “ALL” lights up in the display.
• The total time of the programmed tracks will not be displayed, if a track number higher than 20 is programmed.
• If, during programming, the TEXT/TIME display mode- select button is pressed, the program number display can be changed to display the total time of the programmed tracks or no information. To return to the previous display, press the TEXT/TIME display
• The t and y buttons can be used during playback, but only within the range of the programmed tracks.
• Pressing a numeric button stops the current program and skips to the beginning of the track of the number pressed. Once that track has finished playback, the previously interrupted program resumes playback.
• The e and r buttons can be used during playback to search all tracks, including unprogrammed tracks.
■To stop program play
Press the a button. The first programmed track number will be displayed.
To resume playback, press the w button. Playback will start from the beginning of the program.
■To cancel a programmed sequence
There are several methods, as described below.
•Press the a button or the CLEAR button while the unit is stopped.
•Open the disc tray.
•Press the STANDBY/ON button.
•Switch off the power.
■To check program data
1During program play, press the a button.
2Press the PROG button.
3Each time the y button is pressed, the track numbers and sequential order of the programmed tracks can be checked one after another. The display of the track number can be returned (sequentially in reverse order) by pressing the t button.
■To correct program data
1Follow the procedure described in “To check program data”.
2Display the track number to be corrected by pressing the t or y button.
3Press a numeric button to select a track to replace the one displayed. The previously programmed track will be cleared from the memory and the new one will be programmed.
4After the correction has been completed, press the PROG button or w button once again.
14En