|
| TROUBLESHOOTING |
SYMPTOM | CAUSE | REMEDY |
This unit does not operate | The internal microcomputer has been frozen. | Turn off the power of this unit and then turn on again after |
properly. |
| about one minute (P.14). |
There is rotation noise of | The temperature inside this unit rises. | The fan starts to rotate to cool off the temperature inside |
the fan. |
| this unit. |
A noise occurs at the | A very low frequency component among the | Improvement can be made by adding a short |
change of the tracks that | wow and flutter of the analog record is being | |
has been recorded from the | output as a noise. |
|
analog record and edited. |
|
|
Remote control does not | The batteries of the remote control are too | Replace two batteries with new ones (P.11). |
work. | weak. |
|
| Remote control is from too far. | Use the remote control within 6 m and 60 degrees radius |
| Remote control is being used at an incorrect | (P.11). |
| angle. |
|
| Direct sunlight or lighting (of an inverter type | Change the position so that the remote control sensor is not |
| of fluorescent lamp, etc.) is striking the | exposed to strong lighting. |
| remote control sensor. |
|
TV does not correctly | Remote control is being used near TV set | Relocate this unit away from the TV or cover the TV’s |
function when the remote | with a remote control sensor. | remote control sensor. |
control is being used. |
|
|
The picture on the TV is | The indoor antenna is used. | Use an outdoor antenna, or set this unit away from the TV |
impaired. |
| set. |
|
| 7 |
APPENDIX
77
English