Yamaha CDR-S1000 Manual track marking, Recording directly, from a source CD, English, TRACK NO, TRACK NO, CD DIRECT, TRACK NO. WRITE, TRACK NO. WRITE, Press CD DIRECT again

Manual track marking

You can manually mark tracks as you like anywhere in your recording.TRACK NO.

	NATURAL SOUND CD RECORDER CDR-S1000						INPUT	DIGITAL/ANALOG
								REC LEVEL
							OPTICAL
							COAXIAL	ANALOG
	TRACK NO.	EFFECT	REC MODE	CD DIRECT	REC	REC
					MUTE
								MIN	MAX
POWER	FINALIZE	ERASE	DISPLAY	OPEN/CLOSE	/	/	/
							PHONES	LEVEL
								0	10

		TRACK NO.			OPEN/
TRACK NO.	REC MODE	WRITE	DIMMER DISPLAY		CLOSE
WRITE	EFFECT REPEAT RANDOM CLEAR				PROG
	1	2	3	INDEX
	4	5	6	+10
	7	8	9		0
	FINALIZE ERASE REC			REC MUTE
		SEARCH		SKIP
		STOP	PAUSE	PLAY

While recording, press TRACK NO. (TRACK NO. WRITE on the remote).

•A new track number is added at the location on the disc corresponding to the time TRACK NO. (TRACK NO. WRITE on the remote) is pressed.

•Please note that tracks cannot be shorter than 4 seconds, and that a disc cannot contain more than 99 tracks. Even if there is time remaining on the disc, further recording is impossible once 99 tracks have been recorded.

Notes

•When digitally recording DAT sources, be sure to start recording on the CD-R disc after pausing the source at the beginning of a track (start ID, etc.).

•Manual track marking is recommended for the following:

*When an analog source is being recorded that contains a section or numerous sections with levels too low to be detected on the level meter.

*When recording digital satellite broadcasts•Manual track marking is possible even during synchronized recording.

RECORDING FUNCTIONS

Recording directly	English
from a source CD

Because CD discs are recorded at a sampling rate of 44.1 kHz, this unit makes it possible to make a direct recording of another CD disc that bypasses unnecessary digital processing such as the sampling rate converter.

				CD DIRECT
	NATURAL SOUND CD RECORDER CDR-S1000						INPUT	DIGITAL/ANALOG
								REC LEVEL
							OPTICAL
							COAXIAL	ANALOG
	TRACK NO.	EFFECT	REC MODE	CD DIRECT	REC	REC
					MUTE
								MIN	MAX
POWER	FINALIZE	ERASE	DISPLAY	OPEN/CLOSE	/	/	/
							PHONES	LEVEL
								0	10

1Press CD DIRECT while in record pause mode.•When the CD DIRECT function is on, the CD DIRECT indicator lights.

CD DIRECT

2Perform one of the recording procedures as outlined on pages 13 to 16.•Any of the recording modes may be used.

•When the CD DIRECT indicator is lit, recording level adjustment is not possible. Additionally, dynamic range compression cannot be applied to the recording.

To turn off the CD DIRECT functionPress CD DIRECT again.

Note

•Due to variances in recordings, the CD DIRECT function may not work with all CD discs. If the CD DIRECT function is not possible, pressing CD DIRECT causes the CD DIRECT indicator to blink for 3 seconds and then turn off.

E-18