ADDITIONAL INFORMATION
CD-Recorder system notes and limitations
About track length and number•The CD specifications state that the minimum length of a CD track must be 4 seconds. If a recording is stopped while the track is less than 4 seconds long, the unit will record silence until the 4 second track length requirement has been reached, and then stop recording.
•CD discs can be recorded with up to 99 tracks on them. Recording will be automatically stopped if the 99 track limit is exceeded. Once 99 tracks have been recorded, no further recording is possible even if time is remaining on the disc.
About source sampling rate conversionWhen recording an analog source (such as an LP or cassette), this unit converts the analog signals to a 44.1 kHz digital signal before recording them onto the
When recording a digital source, this unit converts the digital signals to 44.1 kHz for recording onto the
This unit is designed exclusively for recording audio signals.
When recording from a DAT source, make sure that the start IDs on DAT tapes are in positions slightly before the actual audio begins.
DAT tapes that are originally recorded using the DAT recorder’s auto ID function record the start ID slightly after the actual recording begins. Because this recorder uses the start ID on the DAT to indicate the transition between tracks, the following problems may occur during synchronized recording (single track or ALL track).
•The beginning of the audio on a track is not recorded.
•A new track number is created slightly after the beginning of a new track.
•The beginning of the next track is recorded at the end of a recording.
To avoid these potential problems, it is recommended to perform manual recording of DAT sources. For more information on DAT operations, refer to the operating instructions provided with the DAT recorder.