Internal Design of the CP5 & CP50
Reference
Left & Right Parts
[VOICE]
[PRE-AMP]
[MOD-FX]
[PWR-AMP] (CP5 only)
[LEFT1]/[LEFT2]/[RIGHT1]/
[RIGHT2] (CP5)
[LEFT]/[RIGHT] (CP50)
[COMMON]
Song Setting Area
[SONG SETTING]
[RECORD]
TRACK Part
[TRACK]
MIC INPUT Part
[MIC INPUT] (CP5 only)
Settings for All Parts
[REVERB]
Settings for All Performances
[MASTER COMPRESSOR]
[UTILITY]
[FILE]
Appendix

41 CP5/CP50 Reference Manual

Mic Insert Effect Screen

From the Mic Insert Effect screen, you can select and configure an insertion effect to process audio

signals input via the MIC INPUT jack. Depending on the effect selected, this screen can contain up

to six pages.

3CompTh
(Compressor
Threshold)
This parameter is used to set the input level at which the compressor starts com-
pressing the sound.
Setting values: -48dB to -6dB
4CompRat
(Compression Ratio)
This parameter is used to set the compression ratio.
Setting values: 1.0 to 20.0
CompOut
(Compressor Output
Level)
This parameter is used to adjust the compressor’s output level.
Setting values: 0 to 127
5L.Freq
(Low Frequency)
This parameter is used to set a low-band frequency for boosting or cutting of the
sound.
Setting values: 32Hz to 2.0kHz
L.Gain (Low Gain) This parameter is used to set the degree to which low-band frequencies will be
boosted or cut.
Setting values: -12dB to +12dB
6M.Freq
(Mid Frequency)
This parameter is used to set a mid-band frequency around which the sound will
be boosted or cut.
Setting values: 100Hz to 10.0kHz
M.Gain (Mid Gain) This parameter is used to set the degree to which mid-band frequencies will be
boosted or cut.
Setting values: -12dB to +12dB
M.Width (Mid Width) This parameter is used to set the width of the mid-frequency EQ band.
Setting values: 0.1 to 12.0
7H.Freq
(High Frequency)
This parameter is used to set a high-band frequency for boosting or cutting of the
sound.
Setting values: 500Hz to 16.0kHz
H.Gain (High Gain) This parameter is used to set the degree to which high-band frequencies will be
boosted or cut.
Setting values: -12dB to +12dB

Edit Sequence

Press and hold the [MIC INPUT] button (for at least one second) Navigate to Page 2

using the [PAGE ] button or [2] button Press Knob 2 Navigate to the required

page using the [ PAGE] and [PAGE ] buttons Turn Knobs 1 to 3

Page On-screen name
(and full name) Description
1MicInsType
(Mic Insert Effect
Typ e)
This parameter is used to select a category and effect type for the MIC INPUT
part’s audio signals. These categories and effects are identical to those from the
Modulation Effect block’s Other group, and more details can be obtained from the
table on page 16.
2 to 6 Effect parameters The parameters presented on Page 2 onward will depend on the MicInsType set-
tings. For more details, see Parameters for non-piano voice effects (page 19).
Page On-screen name
(and full name) Description