Front and Rear of Unit

Rear Panel

The CRW2200E drive’s rear panel features the following:

➀ ➁ ➂

➃

➄

➀DIGITAL AUDIO OUT connector

If your sound card has a SPDIF (digital audio) input connector, you can connect the DIGITAL AUDIO OUT connector of the unit to the SPDIF connector using a digital audio cable (sold separately).(→P. 22)

➁ANALOG AUDIO OUT connector

Connect one end of the 4-pin audio cable to this and the other end to your computer’s sound card or built-in audio. (→P. 21)

➂Jumper switch

Plug a plastic shunt into this jumper switch to select the connection, either IDE master or slave. The CRW2200E drive’s factory setting is SLAVE. ( →P. 17)

➃IDE INTERFACE CONNECTOR

Insert the connector of the IDE cable here. Make sure you align the red line of the ribbon cable with pin 1 of the drive’s connector, marked “IDE INTERFACE CONNECTOR 1.” ( →P. 20)

➄DC INPUT connector

Insert the power connector from your computer’s power supply in this socket to feed power to the drive. (→P. 23)

8